Ground Clearing
The first step in the installation process is to clear the ground of any covering or debris. A clear base is vital to the longterm quality of our installations. For existing lawns, this may include removal of sod, rocks, gravel, etc. Although new construction installations will not require the same time commitment during this phase, care should be taken to ensure that the ground is clear of any remaining construction debris, or obstructions.
Base Height
The second step in the installation process is to ensure that the installed product will be at the desired finish grade. This requires that the initial base be at approximately 3” to 4” below finish grade. Depending on the current conditions, remove any excess soil, or bring in clean fill dirt at this time.
Gravel Sub-base
Install a crushed aggregate base approximately 3” deep to stabilize the surface and provide drainage. The exact material may vary by location of the country and soil conditions, but we typically recommend a 1/4” minus crusher fine material. The material must be able to be compacted, while still providing for adequate drainage.
Grading
The crushed aggregate needs to be graded (typically with wide contractor rakes) to adjust the contour to meet drainage requirements as well as personal desires. This step allows you to determine the exact finish level of the grass, as well as prevent any areas of water build-up or improper drainage.
Compacting the Base
Use a plate tamper to compact the base. Lightly spray water over the gravel prior to tamping to ensure proper compaction and to reduce dust. The goal ofthis step is to reach 90-95% compaction. This typically takes 2-3 passes. Let the compacted crushed grave sub-base dry and check for inconsistenciesprior to proceeding. If necessary, adjust the gravel level and repeat the compaction.
Eco Grass Layout
Determine how best to lay out the Eco Grassrolls. Eco Grass comes in 15’ wide rolls. Due to the natural direction of the grass blades, the turf must all belaid out in the same direction. Therefore, it is very important that this layout is thoroughly th ought out before cutting begins.
Cutting the Grass
This phase is where the turf is trimmed to fit your yard. The product can be cut around your existing landscape whether it is a perfect square or a winding path that is bordered by rocks. The best method is to lay the grass out and mark the back of the grass with a permanent marker where you want the cut. Then rollthe grass over and cut it with a sharp utility knife. Be careful not to cut through any grass that might be lying underneath.
